Dual CT measurement node with wireless bridge to Touch Pro and Home Assistant. RS-485 and CAN bus connectivity for inverters, charge controllers, and battery systems. One device replaces what used to take several.
US residential service is split-phase 120/240V. Most inverter limiters only see one leg. Link Pro sees both and bridges the data wirelessly to every device on the ClaroWatt Ecosystem Network.
Two CT inputs, one per leg of your split-phase service. Link Pro reads both simultaneously and reports the true combined load. No single-phase guesswork, no throttling from bad data.
Direct wired connection to inverter limiter ports via RS-485 Modbus RTU. CAN bus support for charge controllers, battery systems, and Victron equipment. Link Pro bridges all of it wirelessly to Touch Pro.
Everything Link Pro reads over RS-485 and CAN goes straight across the ClaroWatt Ecosystem Network to Touch Pro and Home Assistant. No additional wiring between devices, no configuration.
The ClaroWatt Ecosystem Network means every device finds every other device automatically. No re-pairing, no IP addresses, no configuration. Link Pro connects at power-on and starts bridging immediately.
True split-phase measurement for the full range of US residential inverters. Growatt, SolarEdge, Hoymiles, EcoFlow and others receive accurate limiter data via RS-485.
CAN bus connectivity for Victron charge controllers, inverters, and shunts. State of charge, current, and system status forwarded wirelessly to Touch Pro and Home Assistant.
EcoFlow, Bluetti, Anker SOLIX, Jackery. Portable power stations on the Ecosystem Network. Know your state before you need it.
Every device on the Ecosystem Network is a native HA entity. One-click discovery, no YAML. Full Energy Dashboard and automations on real split-phase data.
Two CT sensor inputs, one per phase of your split-phase service. Link Pro reads both legs at the same time and reports the true combined picture to your inverter and the rest of the ClaroWatt Ecosystem Network.
RS-485 Modbus RTU output connects directly to your inverter limiter port. CAN bus handles Victron equipment, charge controllers, and battery management systems. Link Pro reads both protocols and forwards everything wirelessly to Touch Pro.
All data collected over CT, RS-485, and CAN is broadcast wirelessly to Touch Pro and Home Assistant with no additional configuration. Link Pro is the field node; Touch Pro is the display and brain. They find each other automatically.
Link Pro is headless by design. Four status LEDs cover power, CT1, CT2, and comms. Everything else lives on Touch Pro or in Home Assistant where it belongs.
Same cable as Touch Pro, same cable as your phone. No special adapter, no bare wire, no electrician required. One USB-C port powers Link Pro and connects it to the world.
Link Pro is available through the ClaroWatt dealer and installer network. The dealer program has pricing and support sorted for installers who want to carry it.
Tell us about your setup and we will be in touch.